Glue the Water-Chip to your water bottle, water purifier and all kinds of water containers and leave for a minimum of 30 minutes. Ideally, allow activation to take effect over 24 hours (drinking water storage tank). Use the Chip for the duration.
Service life: a minimum of 30 years
The Water-Chip has a sphere of activity from 30-50 cm. It can either be attached with glue, or left in the packaging and used in various places. The Water-Chip should be protected from extreme heat (over 50 degrees Celsius). That means no Water-Chip on the kettle (at least not directly on the jug), etc. The Chip is washable. Its effectiveness is further reinforced by metal (it can therefore also be attached to metal containers, etc). Ideally, leave the Water-Chip to work on a water container for 24 hours. This means that the redox potential (antioxidation) is perfected.
Emoto water crystal
Via the Emoto laboratory (Hado Life), an energy measurement was carried out with the Meta-Converter and water. In order to do this, a glass of neutral water (see below, osmosis water) was vitalised for one hour with the Meta-Converter. The result after one hour is absolutely amazing and shows what a wonderful change in frequency the i-like Chip can achieve.
Testing evidence and measurements
Osmosis water was vitalised with the chip from i-like. The result is amazing!
|Prior to application,without the Chip.
||After an hour,with a Chip.
The measurement by the Emoto laboratory (Hado Life) shows what positive frequency changes can be achieved with the chip.
With the Water-chip the stability and order of the water is established and brings the original properties of water back: lively, fresh and powerful. The result is a soft, very harmonious water with high antioxidant activity.